![]() To pause a session, press the Start/Stop button on the timer in the tanning room. If there is no delay entered, the session will start immediately. When the session starts, the period will flash at once per second rate. A period on the lower right corner of the display will flash rapidly. If a delay other than 0 is set, the delay will count down. Next press the Start/Stop button on the front desk T-Max® 3A to start the session. To start a session, press the Up or Down Button on the T-Max® 3A at the front desk until the session time is displayed. When setting the delay (parameter 3), set the delay on the Master T-Max® 3A (the T-Max® 3A at the front desk). A flashing period means the address is over address 100. When setting the address (parameter 1), make sure the period is not flashing. ![]() Set the address on the T-Max® 3A in the tanning room to “1”, and the address on the T-Max® 3A at the front desk to “0” as described in the setting parameters section of this manual. Connect the G2 power injector to the T-Max® 3A as described in the G2 Power injector Users guide. Note: If you are using the G2 wireless adapters, you do not need to run the modular cable. Connect the modular cable to one of the RJ-22 ports on each T-Max® 3A. Run the provided modular cable from the tanning room to the remote T-Max® 3A. Plug each power supply into a 120VAC outlet.Ĭonnect the T-Max® 3A in the tanning room to the tanning bed as described. Place one T-Max® 3A in the tanning room and one at the desired remote location.Ĭonnect the 9V 300mA power supply to the “Pwr In” screw terminal on the back of each T-Max® 3A. Two T-Max® timers are required for remote single bed control:Ī T-Max® 3A at the front desk (referred to as the Master) and a T-Max® timer in the tanning room (either a T-Max® 3A or a T-Max® certified in bed timer.Ī Master T-Max® 3A can only control one T-Max® timer in the tanning room. Remote single bed control is the ability to control a T-Max® timer in the tanning room with a T-Max® 3A at the front desk. Quote: REMOTE SINGLE BED CONTROL (Master-Slave)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |